This will make all imperfections pop out. As an easy tip that I typically do on jobs, use a portable LED light and cast it at an angle on the wall or ceiling. Once dry, you’ll need to sand either by hand, or my preference is a dustless drywall sander. Use a minimum 150-grit sandpaper to remove any imperfections or rough spots. Drying and SandingĪllow the first coat to dry completely, which usually takes about 24 hours. Work in long, continuous strokes, overlapping each pass slightly. Gently glide it over the coated area, applying even pressure to remove excess mud and create a smooth finish. Once the first coat is applied, take your large skimming blade and hold it at a slight angle to the surface. If you don’t want to use this process to apply the drywall mud, I recommend using a 12″ knife to lay the mud on the wall or ceiling instead. Ensure that the layer is as smooth as possible. Start in a corner and work your way outward in manageable sections. Use a paint roller with a smooth nap to apply a thin and even coat of thinned drywall mud to the wall or ceiling. The goal is to achieve a consistency similar to pancake batter. If the mud is too thick, add a small amount of water and mix until it’s easier to spread. In a clean bucket, mix the drywall mud thoroughly with water until it reaches a creamy consistency.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |